Install Cameras: APPCAM25HD Outdoor HD WiFi

Consider the following when installing cameras:

• Clear line of sight video transmission distance is best.

— Walls, especially brick and concrete, shorten the transmission distance.

— Placement next to windows allows better transmission.

• Avoid having a direct light source in the view of the camera, including street lights, ceiling or floor lamps, spotlights in the driveway, etc.

• The camera is equipped with built-in infrared LEDs so you can use night vision for 24-hour surveillance. The LEDs will automatically activate at night and the picture viewed will turn to black and white. The night viewing range is up to 40 ft. Avoid pointing the camera lens directly at clear glass; the night vision LEDs will cause a blurred image.

• Optimized motion detection range is 6 - 18 feet for the camera. The farther away an object is, the less accurate the motion detection.

Avoid pointing the camera directly at any bushes, tree branches, or moving objects that might naturally move due to winds. Otherwise, the motion detection feature may record unnecessarily.

You can mount the AppCam 25HD with the stand on the bottom (on a flat surface such as a table-top), on the side (on a wall), or on the top (on the ceiling or under an eave or overhang).

1. Use your mobile device to test the places where you are considering mounting the camera. Hold the device in that location; if you still have a WiFi signal on your device, the location should be okay. Attach the camera stand if you have not already done so.

2. Unplug the camera from the power source and install it.

3. After the camera is installed, reconnect power.

Mount the AppCam 25HD Base

1. Hold the base of the camera stand where you want to mount it and mark the location of the screw holes.

2. Use the included screws and anchors to attach the base to the wall or ceiling. You can also screw the base into a flat surface such as a tabletop if needed.

3. Before attaching the camera, tug gently on the stand to make sure it is securely in place.

Attach the AppCam 25HD Camera

1. For each AppCam 25HD, attach the camera bracket to the mounting screw. You can attach the stand to the top or the bottom of the AppCam 25HD as needed. Tighten it a few turns, then turn the AppCam 25HD to face the direction you want.

2. Tighten the camera brace up against the AppCam 25HD to secure it into place.

3. Unlock the mounting post by turning the wingnut to the left a few turns.

4. Set the mounting post to the correct angle, then tighten the wingnut until the post is locked into place.

5. After the AppCam 25HD camera is installed, reconnect power.