3D Printer User Guide : Installing Filament of FLASHFORGE DREAMER 3D Printer

Installing Filament

The parts needed to complete this section of the hardware assembly include the following:

• 2 Filament spool holder

• 2 Filament guide tube

• 2 Dreamer filament rolls (included in the box

Below shows the suggested path the filament should travel from the filament spool to the extruder.

1. Begin by loosening the filament guide tube bracket on the back of the Dreamer just enough so that it can move freely.

2. Remove a pack of filament that is included with the Dreamer. Also, find the filament spool holder. Place the filament onto the filament seat. Make sure the direction of the filament is going upwards as shown.

3. Lock the filament in place by securing it with the filament spool holder and turning it counter-clockwise.

4. Feed the filament through the filament guide tube. Attach the guide tube onto the two filament guide tube brackets.

5. Then from the guide tube, feed the filament directly into the extruder.

6. Repeat steps 1 to 5 for installing the other filament.
Plugging in Power Cord & USB Cable

1. Locate the power cord, and plug it into the Dreamer.
Optional: Locate the USB cord and plug one end into the Dreamer and the other into your computer. The Dreamer supports USB 2.0.