3D Printer Software for BUILDER

Cura (Windows, MAC, Linux)

Cura is a open source program which prepares your object into a file (gcode) that can be read

by the Builder 3D printer.

• Download Cura software

• After installing Cura, select Custom machine and enter the sizes of your Builder

• Download the INI-files for your Builder 3D printer

• Load the INI-files in Cura by using the option “open profile”

• Enter the number of extruders in the “Machine settings” menu

• Reopen this menu and set the extruders offset (X-Y) values to zero.

• For more information about Cura, check the manual.

Repetier

Repetier Host prepares your object into a file (gcode) that can be read by the Builder 3D printer.

• Download Repetier Host from our website http://3dprinter4u.nl/3d-printer-installatie/.

• Repetier Host is adjusted to the settings of the Builder 3D printer

• For more information about Repetier Host, check chapter “Repetier Host”

Repetier for MAC

The following steps should be taken to be able using the settings

of builder in Slic3r.

1. Use the following link http://3dprinter4u.com/3d-printer-installation.

Go ahead to step 2 and download the Ini-files

2. Start Repetier-Host

3. Open the tab Slic3r

4. Press “Configure” to activate Slic3r.

5. Choose “Load Config” in the file menu.